• viewed loo...

    2650080-R2-024-10A.jpg viewed looking down @ 190 degree thermostst screwed into lower thermostat housing. green wire runs to dual relays mounted on drivers inner fender relays. image by 1951otter

  • another vi...

    2650080-R2-022-9A.jpg another view of 190degree thermostat switch screwed into engine housing. image by 1951otter

  •  

    9A-1.jpg image by 1951otter

  • T. Langdon...

    8A-2.jpg T. Langdon 'stovebolt' 3+3 headers. If you run these w/ a stock steering box and brake pedal assy... YOU MUST have tom cut and re-weld exh. flanges as shown to to clear everything. image by 1951otter

  • Mr. Gasket...

    7A-2.jpg Mr. Gasket bellcrank w/ square rod to stock pedal, 3/8in. water tube showing. image by 1951otter

  • langdon 'S...

    6A-1.jpg langdon 'STOVEBOLT' headers image by 1951otter

  • close fit ...

    5A-1.jpg close fit between the brake arm and langdon's headers. Tom can re-weld these to fit your truck image by 1951otter

  • BOTH the f...

    4A-1.jpg BOTH the front and rear of Langdon's headers had to be cut and have the exh pipe connection re-welded to clear the steering box and throttle linkage image by 1951otter

  • rear Langd...

    3A-2.jpg rear Langdon stovebolt header had a mod done to clear the throttle linkage as well as the brake pedal arm as it works. image by 1951otter

  • in-line L6...

    1A-3.jpg in-line L6 oil primer made from an old points dist. points rotor brazed back on so a socket and electric drill can drive unit. this pumps oil through out engine B4 starting. image by 1951otter

  • old points...

    0A-2.jpg old points dist re-worked to prime oil through out engine B4 start up. gear teeth were cut down so cam would not get engaged. image by 1951otter

  • courtesy l...

    17A1.jpg courtesy lamps were tucked up under edge of dash ... same on drivers side. ALL four lamps light when door is opened image by 1951otter

  • drivers si...

    12.jpg drivers side of 292 installed motor mounts e/w biscuit rubber kit.. note acc bellcrank assy for throttle pedal to lokar cable. image by 1951otter

  • 292 instal...

    11.jpg 292 installed in 3104 image by 1951otter

  • slippin th...

    10.jpg slippin that puppy in our Lucinda note T5 image by 1951otter

  • water bott...

    9.jpg water bottle on firewall, T5 on 292 image by 1951otter

  • lucinda's ...

    8.jpg lucinda's getting a heart and lungs image by 1951otter

  • 3104 frame...

    7.jpg 3104 frame offset engine mounts supplied by Buffalo Steve. these puppies are strong image by 1951otter

  • view just ...

    6.jpg view just before i slipped the new 292 and T5 into Lucinda Otter Purr (51). note welded visor onto gutter tabs for mount. NO clip-on cheap mounts here. image by 1951otter

  • T5 center ...

    14.jpg T5 center support using a box 2x3'' and stock chevy rubber mount image by 1951otter
View all |  prev 1 2 3 4 5 6 7 8 9 10 ... 19 20 Next
Theme: Classic (preview it in your album)
Feed for this album
Feed for all 1951otter's content

8,658,355,834 (That's billions of images)

popular searches:  humor, miley cyrus, i love you, friends, best friends, lil wayne, glitter, stars, icons, photography, retro, backgrounds, kiss, love, tattoos

© 2009 photobucket inc. all rights reserved.